This topic describes configuring Stax Bill for credit card payment processing via the First Data gateway.
First Data supports both Address Verification and CCV/CVV.
To complete the setup, you will need to log in to First Data and copy the following information into the Stax Bill configuration pop-up:
-
First Data Gateway ID
-
First Data Password
-
First Data Hmac Key
-
First Data Key ID
Tip
For more information about First Data, visit their website.
To configure your payment gateway:
-
In Stax Bill, navigate to Settings >Collections >Gateways and click Show Other Supported Gateways.
-
Under "Credit Card," click First Data. The Stax Bill configuration pop-up appears.
-
Login to the First Data Global Gateway, click Administration and select the Terminals tab. Select the ECOMM terminal.
-
Copy the Gateway ID and paste it into the Stax Bill configuration pop-up.
-
Copy the password and paste it into the Stax Bill configuration pop-up.
If a password does not exist, click Generate to create a new one, then copy and paste it into the Stax Bill configuration pop-up.
-
Select the API Access tab.
-
Copy the Key ID and the Hmac key and paste them into the Stax Bill configuration popup.
If the Hmac key does not exist, click Generate New Key to create a new one.
-
If you are working in a First Data test environment, ensure Developer Mode is selected.
Warning
Stax Bill will still interpret all transactions as legitimate, so you need to refund charges made in this mode to maintain proper ledger balances in Stax Bill.
Note
The sample credit card numbers provided by Stax Bill may work with your gateway in Developer Mode; however, Stax Bill recommends contacting your payment processor to obtain their test numbers.
-
Click Save.